Chowdhury S , Chanda B .

GM084140 NIGMS NIH HHS , R01 GM084140-05 NIGMS NIH HHS , R01 GM084140 NIGMS NIH HHS

	Figure 1. Free energy measures from a QV curve. (A) A hypothetical normalized QV curve. The vertical dashed line is the V = 0 axis. The shaded area is the integral ∫01V dQ−f (Q−f=Q−/Qmax), which equals ΔG−C/Qmax. The integral is negative on the left of the V = 0 axis and positive on the right, as indicated by the − and + signs. (B) The same QV curve with the median voltage of charge movement (Vm) marked by the vertical dashed lines. The areas on either side of the Vm axis are equal and are both positive. (C) The QV curve intersected by the V = 0 and V = Vm axes. The area of the shaded rectangle is equal to the sum of the two areas shaded in A, taking their respective signs into consideration.
	Figure 2. QV curves of the Shaker potassium channel and the rNaV1.4 channel. Normalized QV curves for Sh-IR W434F and NaV1.4. Each curve is a mean of independent measurements from five oocytes. The normalized QV curve for the ILT mutant was simulated according to the kinetic model proposed by Ledwell and Aldrich (1999).
	Figure 3. Effect of an intermediate voltage-independent step on the free energy estimates. (A) A six-state linear model of activation of a voltage-dependent ion channel with five closed state and a single final open state. The voltage dependence of the equilibrium constants is given by Ki=Ki0exp(ziFVβ) (i = 1, 2, 3, 4, or 5), where Ki0 is the chemical component of the equilibrium constant Ki and zi is its voltage dependence. The third step (shown in bold) is voltage independent, and thus z3 = 0. ΔG−C is the sum of the chemical free energy change of each of the steps and will equal −RTln∏i=15Ki0. (B) QmaxFVm is plotted against ΔG−C for different values of log K30 (−5 to 5) and two values of z2 (closed squares, z2 = 5; and open triangles, z2 = 0). The remaining parameters of the model were arbitrarily chosen as K10 = 1, K20 = 75, K40 = 25, K50 = 5, z1 = 2, z3 = 0, z4 = 2.5, and z5 = 1. (C and D) Variation of ΔG−C (C) and Vm (D) with changing values of z2 (0–5) and log K30.
	Figure 4. Effect of terminal voltage-independent steps on the free energy estimates. (A) Two six-state linear schemes of voltage-dependent activation of a channel. In both schemes, except for the final transition (in bold), all other steps are voltage dependent. Scheme II has one open state, whereas scheme II has two open states. The voltage dependence of each of the equilibrium parameters in schemes II and III is defined similar to those in scheme I (Fig. 3 A). For schemes II and III, z5 = 0. (B) Results of the numerical simulations performed using scheme II. K30 = 10, z2 = 1.5, z3 = 1, and z5 = 0. The remaining parameters were same as those in scheme I (Fig. 3 A). K50 was varied from 0.001 to 2,097.15. The relation between the free energy difference between the initial and final states, ΔG−C (−RTln∏i=15Ki0), and the free energy change in the ensemble, QmaxFVm (closed symbols) and −RTlnPOmax (open symbols), for different values of K50. Adding QmaxFVm and the correction factor, −RTlnPOmax, gives ΔG−C, as depicted by the dashed line. (C) POmax values calculated at different values of K50 for scheme II (A).
	Figure 5. Influence of latent charge movement and cooperativity on inferred energetics. (A) A 10-state MWC cooperative scheme of voltage-dependent ion channel activation. The channel comprises four identical voltage-sensing modules and one pore domain, each capable of existing in two conformations. States Ci and Oi differ in the conformational status of the pore domain, whereas the different Cis and Ois differ among each other in the number of activated voltage-sensing modules (i = 0, 1,…, 4). Activation of the each of the voltage sensors facilitates the opening transition of the pore and vice versa. The number alongside each state indicates its multiplicity. The voltage dependence of the equilibrium constant for activation of the pore and voltage sensors follows the relation Ki=Ki0exp(ziFVβ) (i = V, P). (B) Plot of QmaxFVm against ΔG−C for different values of θ (varied between 5 and 80) and two values of zV (open triangles, zV = 1; closed squares, zV = 3). The other model parameters were chosen to be KV0 = 20, KP0 = 10−5, and zP = 1.5. Different values of zV lead to different latent charge movement. (C) Plot of QmaxFVm and −RTlnPOmax against ΔG−C for different values of θ (varied between 5 and 80) when zP = 0. The arrow shows the value of θ and POmax beyond which ΔG−C and QmaxFVm deviate. For these simulations, KV0 = 20, KP0 = 10−5, and zV = 3. POmin in each case was ∼0. Adding QmaxFVm and the correction factor, −RTlnPOmax, gives ΔG−C, as depicted by the dashed line. (D) Plot of QmaxFVm and −RTln(1−POmin) against ΔG−C for different values of KP0 (varied between 10−5 and 50) when zP = 0. The arrow shows the value of KP0 and POmin below which ΔG−C and QmaxFVm deviate. For these simulations, KV0 = 20, θ = 20, and zV = 3. POmax in each case was ∼1. Adding QmaxFVm and the correction factor, −RTln(1−POmin), givesΔG−C, as depicted by the dashed line.
	Figure 6. Influence of inactivation on the median estimate of free energy change. (A) An eight-state model for an inactivating channel. The encircled states represent the initial reference state (VRPCIR, red) and the final state (VAPOIA, black) of the system. In the final state, all of the units of the system are in their activated/open conformations, whereas in the reference state, all are in their resting/closed conformations. The equilibrium constants are assumed to have an exponential voltage dependence, Ki=Ki0exp(ziFVβ), (i = 1, 2,…, 12). (B) An equivalent nested coupled model of inactivation. The conformational transitions in each of the structural units are Ki=Ki0exp(ziFVβ), where i is V, P, or inact. The pairwise coupling parameters, θVP, θPI, and θIV, denote the voltage-independent coupling between units V and P, P and I, and I and V, respectively. The parameters of the cubic model can be related to those of the nested model. For instance, K10 = Kinact and K11 = KinactθPIθIV. (C) Plot of QmaxFVm against ΔG−C for different values of Kinact0 (varied between 0.0001 and 0.0256) and two values of zinact. The remaining parameters were arbitrarily chosen to be KV0 = 75, KP0 = 1, θVP = 5, θPI = 8, θIV = 100, zV = 3, and zP = 1. Here, ΔG−C=−RTlnKVRPCIR→VAPOIA0=−RTln(K10K20K110)=−RTln(KV0KP0Kinact0θVPθPIθIV). (D) Maximum fraction of inactivated channels at depolarizing voltages for different values of Kinact0.

Aggarwal, Contribution of the S4 segment to gating charge in the Shaker K+ channel. 1996, Pubmed, Xenbase

Aggarwal, Contribution of the S4 segment to gating charge in the Shaker K+ channel. 1996, Pubmed , Xenbase
Armstrong, Currents related to movement of the gating particles of the sodium channels. 1973, Pubmed
Bezanilla, The voltage sensor in voltage-dependent ion channels. 2000, Pubmed
Bezanilla, Gating of Shaker K+ channels: II. The components of gating currents and a model of channel activation. 1994, Pubmed , Xenbase
COLE, Potassium ion current in the squid giant axon: dynamic characteristic. 1960, Pubmed
Chowdhury, Deconstructing thermodynamic parameters of a coupled system from site-specific observables. 2010, Pubmed
DeCaen, Disulfide locking a sodium channel voltage sensor reveals ion pair formation during activation. 2008, Pubmed
Gagnon, The contribution of individual subunits to the coupling of the voltage sensor to pore opening in Shaker K channels: effect of ILT mutations in heterotetramers. 2010, Pubmed , Xenbase
Gonzalez, Modulation of the Shaker K(+) channel gating kinetics by the S3-S4 linker. 2000, Pubmed , Xenbase
Gonzalez, Periodic perturbations in Shaker K+ channel gating kinetics by deletions in the S3-S4 linker. 2001, Pubmed , Xenbase
Hackos, Scanning the intracellular S6 activation gate in the shaker K+ channel. 2002, Pubmed , Xenbase
Hirschberg, Transfer of twelve charges is needed to open skeletal muscle Na+ channels. 1995, Pubmed , Xenbase
Horrigan, Coupling between voltage sensor activation, Ca2+ binding and channel opening in large conductance (BK) potassium channels. 2002, Pubmed , Xenbase
Horrigan, Allosteric voltage gating of potassium channels II. Mslo channel gating charge movement in the absence of Ca(2+). 1999, Pubmed
Lacroix, Control of a final gating charge transition by a hydrophobic residue in the S2 segment of a K+ channel voltage sensor. 2011, Pubmed , Xenbase
Ledwell, Mutations in the S4 region isolate the final voltage-dependent cooperative step in potassium channel activation. 1999, Pubmed , Xenbase
Lehmann-Horn, Voltage-gated ion channels and hereditary disease. 1999, Pubmed
Li-Smerin, alpha-helical structural elements within the voltage-sensing domains of a K(+) channel. 2000, Pubmed , Xenbase
Li-Smerin, A localized interaction surface for voltage-sensing domains on the pore domain of a K+ channel. 2000, Pubmed , Xenbase
MONOD, ON THE NATURE OF ALLOSTERIC TRANSITIONS: A PLAUSIBLE MODEL. 1965, Pubmed
McCormack, A role for hydrophobic residues in the voltage-dependent gating of Shaker K+ channels. 1991, Pubmed , Xenbase
Miller, Model-free free energy for voltage-gated channels. 2011, Pubmed
Monks, Helical structure and packing orientation of the S2 segment in the Shaker K+ channel. 1999, Pubmed , Xenbase
Muroi, Molecular determinants of coupling between the domain III voltage sensor and pore of a sodium channel. 2010, Pubmed
Perozo, Gating currents from a nonconducting mutant reveal open-closed conformations in Shaker K+ channels. 1993, Pubmed
Perozo, S4 mutations alter gating currents of Shaker K channels. 1994, Pubmed , Xenbase
Rodríguez, Voltage gating of Shaker K+ channels. The effect of temperature on ionic and gating currents. 1998, Pubmed , Xenbase
Roux, Influence of the membrane potential on the free energy of an intrinsic protein. 1997, Pubmed
Sadovsky, Principles underlying energetic coupling along an allosteric communication trajectory of a voltage-activated K+ channel. 2007, Pubmed
Schoppa, The size of gating charge in wild-type and mutant Shaker potassium channels. 1992, Pubmed
Schoppa, Activation of Shaker potassium channels. III. An activation gating model for wild-type and V2 mutant channels. 1998, Pubmed , Xenbase
Seoh, Voltage-sensing residues in the S2 and S4 segments of the Shaker K+ channel. 1996, Pubmed , Xenbase
Sigg, Total charge movement per channel. The relation between gating charge displacement and the voltage sensitivity of activation. 1997, Pubmed
Sigworth, Voltage gating of ion channels. 1994, Pubmed
Smith-Maxwell, Role of the S4 in cooperativity of voltage-dependent potassium channel activation. 1998, Pubmed , Xenbase
Smith-Maxwell, Uncharged S4 residues and cooperativity in voltage-dependent potassium channel activation. 1998, Pubmed , Xenbase
Soler-Llavina, Functional interactions at the interface between voltage-sensing and pore domains in the Shaker K(v) channel. 2006, Pubmed , Xenbase
Stevens, Interactions between intrinsic membrane protein and electric field. An approach to studying nerve excitability. 1978, Pubmed
Tao, A gating charge transfer center in voltage sensors. 2010, Pubmed , Xenbase
Vandenberg, A sodium channel gating model based on single channel, macroscopic ionic, and gating currents in the squid giant axon. 1991, Pubmed
Villalba-Galea, S4-based voltage sensors have three major conformations. 2008, Pubmed
WYMAN, LINKED FUNCTIONS AND RECIPROCAL EFFECTS IN HEMOGLOBIN: A SECOND LOOK. 1964, Pubmed
Xu, A shaker K+ channel with a miniature engineered voltage sensor. 2010, Pubmed
Yifrach, Energetics of pore opening in a voltage-gated K(+) channel. 2002, Pubmed , Xenbase
Zagotta, Shaker potassium channel gating. II: Transitions in the activation pathway. 1994, Pubmed , Xenbase
Zagotta, Shaker potassium channel gating. III: Evaluation of kinetic models for activation. 1994, Pubmed , Xenbase